waveshare 1.27inch RGB OLED Display Module, 128x96 Pixels 262K Colors OLED Display,Compatible with Raspberry Pi/Arduino/STM32,SSD1351 Driver,SPI Interface

Description 1.27inch OLED Display Module Embedded SSD1351 Driver Chip, SPI Communication Comes with examples for Raspberry Pi, Arduino, STM32, etc. Overview Operating voltage: 3.3V/5V (Please ensure that the power supply voltage and logic voltage are consistent, otherwise it will not work properly) Support interface: 4-wire SPI, 3-wire SPI Controller: SSD1351 Resolution: 128(H)RGB x 96(V) Dimension: 25.708 × 19.28mm Pixel size: 0.047 × 0.185mm Display color: 262K color Pinout RES---Reset, low active DC---Data/Command selection (high for data, low for command) CS---Chip selection, low active CLK---Clock input DIN---Data input GND---Ground VCC---Power (3.3V / 5V input) PS: This module only has SPI interface, please pay attention when using it. OLED and its controller The built-in driver used by this OLED is SSD1351, which is a 128RGB * 128 Dot Matrix OLED/PLED controller with a 128*128*18bit SRAM as a display buffer area, which supports two color depths of 262k and 65k. And supports 8bit 8080 parallel, 8bit 6800 parallel, 3wire-SPI and 4wire-SPI and other communication methods. This module selects 4wire-SPI and 3wire-SPI as the communication method, which reduces the area of the module and saves the IO resources of the controller. Package Content 1.27inch RGB OLED Module x1 GH1.25 7PIN cable x1 FAQ 1.This module only has SPI interface, please pay attention when using it? The OLED module is used in a 3.3V system by default, but after our 24+ hour aging test, we found that it works fine in a 5V system. 2.How many hours does the OLED module last? Under normal operating conditions, there are typically 50,000 hours. Note Development Resources is provided , please contact us if you have any problem .