Raspberry Pi 3 B+ Protective Acrylic Case Geekworm Enclosure for Raspberry Pi 3 Model B+, 3B, 2B, B+ / X920(X900) DAC Board/Raspberry pi Hat Expansion Board

[Note] The Raspberry Pi Board is not included; The X920 and X900 Board are not included. This case is raspberry pi HAT size, so you can use it on any board compatible with HAT size, the only things you need to think is the height of copper space; We strongly recommend that you can use this case with our 120 pieces/lot M2.5 standoff+screw+nuts kit to meet your needs;(for the M2.5 kit, please refer to: https://www.amazon.com/dp/B0756CW6Y2) Please REMOVE the PROTECTIVE FILM from both sides of the pieces. [Packing List] 1 x Acrylic Case 1 x Pack of Screws [Overview] It is a perfect acrylic case to install your X900 or X920 expansion board OR other raspberry pi hat expansion board with Raspberry Pi 3 B+ / Pi3 Model B/ 2B / B+ mother board. This is a Protection solution for non-standard boards running boards on top of the RP3, but Please note, this case only compatible with those board which are fitted with the raspberry pi hat, and please check the size of the case carefully to make sure that it will meet your need. [Installation Guide](x920 as a example) 1/ Mount the bottom shell to the Raspberry Pi Motherboard with 5mm screws 2/ Install the 11mm Screws on the Raspberry pi board(as the picture show) 3/ Install the Expansion board 4/ Install the 18mm screws on the X920 Board(as the picture show) 5/ Finally, Install the top shell with 6mm screws (as the picture show)