PowMr 60a Charge Controller - Solar Panel Charge Controller 12V 24V, Max 48V 1560W Input Adjustable Parameter LCD Display Current/Capacity and Timer Setting ON/Off with 5V Dual USB

NOTE :Please Make sure your battery has enough voltage before first installation.(at least 60%) System Voltage: 12V 24V Auto Charge current: 60A Max input power: 780W(12V system); 1560W(24V system) USB output: Dual USB output, 5V/2.5A Max input voltage: 24V(12V system); 48V(24V system) Batteries: Only fit for OPEN, AGM, GEL Float charge: 13.7V(defaul, adjustable) Discharge reconnect voltage: 12.6V(defaul, adjustable) Float charge: 13.7V(defaul, adjustable) Discharge reconnect voltage: 12.6V(defaul, adjustable) Discharge stop voltage: 10.7(defaul, adjustable) Turn ON/OFF light voltage: Solar pannel 8V. Temperature: -35?~+60? Self-consume: <10mA Size/Weight: 193mm*51mm*98mm/390g Load mode: 1. ?0H?Light control mode. [controller recognize voltage auto, if solar panel's voltage under 8V, Load will turn on] 2. ?1-15H?Light controller+ Set an specific time to turn off your load. 3. ?24H? Load always turn on. [except your battery's voltage is too low to read] MENU?1. Press to browse parameters. 2.Press and hold about 3 seconds to enter detail setting UP: Press to increase value DOWN: Press to decrease value TIPS OF INSTALLTION: (ALWAYS CONNECT BATTERY FIRST!!) Step 1, Screw the adjustment screw counter clockwise until the plates moves down. Step 2, Please peel off the coating of the cable tip by about 8 to 10 mm, then insert the wire into the new opening between the plate and the "top" of the Terminal hole, not under it. Step 3, Screw the adjuster clockwise and the plate will move upwards thereby squishing the wire in the Terminal hole, Make sure all connections are tight.