Aideepen 3PCS ESP8266 ESP01 Remote Serial Port Wireless WiFi Transceiver Microcontroller Module AP+STA for Arduino

Using this module for your next Interet of Things project, home automation, or remote sensor project. This module adats the ESP8226 IC for use over a serial connection using simple AT commands. No SPI interface or Know-How is required. Specifications: -SDIO 2.0, SPI, UART - 802.11 b/g/n - I2S interface for high fidelity audio applications - Integrated TCP/IP protocol stack -Standby power consumption of < 1.0mW (DTIM3) - Wake up and transmit packets in < 2ms - Power down leakage current: <10µA - +19.5dBm output in 802.11b mode - Flash Memory Size: 1MB (8Mbit) Features: Wi-Fi Direct (P2P), soft-AP Integrated TCP/IP protocol stack Integrated TR switch, balun, LNA, power amplifier and matching network Integrated PLLs, regulators, DCXO and power management units Integrated low power 32-bit CPU could be used as application processor Integrated WEP, TKIP, AES, and WAPI engines Supports APSD for optimal VoIP applications Supports Bluetooth co-existence interface Supporting LWIP agreement Supporting 3 modes: AP, STA, AP+STA Attention: This module requires a 3.3 volt supply for VCC, and 3.3V logic. It is not 5V tolant. Connect RX or TX on 5V Arduino will destroy this module. You must use a logic level converter, or a 3.3V Arduino The 3.3V supply on the Arduino Uno has inadequate current capabilit to power this module. You must provide a separate and higher 3.3V supply(about 300mA or better) Package Included: 3 x ESP8266 Esp-01 Wifi Transceiver Module