waveshare 4inch HDMI Resistive Touch Screen IPS LCD (Type H) Display 480x800 No I/Os Required Designed for All Revision of Raspberry Pi

Features

4inch IPS screen, 480x800 hardware resolution

Resistive touch control

Compatible and Direct-connect with any revision of Raspberry Pi (except the Pi 1 model B or Pi Zero, which requires an HDMI cable)

Drivers provided (works with your own Raspbian/Ubuntu/Kali/Retropie)

Also works as a computer monitor, in this case, touch panel is unavailable and HDMI cable is required

HDMI interface for displaying, no I/Os required (however, the touch panel still needs I/Os)

3.5mm audio jack, supports HDMI audio output

Backlight can be turned off to lower power consumption

Package Contains 4inch HDMI LCD (H) x 1 HDMI connector x 1 Touch pen x 1 RPi screws pack (4pcs) x 1 FAQ Why the LCD doesn't work with my Raspbian? To use the LCD with the Raspberry Pi official image, driver should be installed first. Please refer to the user manual. However, for the first testing, you may want to use our provided image directly. Why the LCD still doesn't work with the Waveshare provided image? Make sure the hardware connection is correct and connects fine. Make sure the image in TF card is burnt correctly. The PWR will keep on and the ACT will keep blinking when the Raspberry Pi starts up successfully, in case both of the two LEDs keep on, it is possible that the image was burnt incorrectly OR the TF card was in bad contact. Which power supply should I use? It is recommended to use a 5V/3A power adapter for the Raspberry Pi other than USB connection, otherwise the Pi may failed to start up because the PC's USB port might have not enough power. For large size LCDs, say, 10inch diagonal or more, another stand-alone power adapter is also required to provide power to the LCD.