Waveshare 296×128 2.9inch Flexible E-Ink Display HAT for Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+, Jetson Nano, Black/White Dual-Color SPI Interface Display Section Bendable

Overview This is a flexible E-Ink display HAT for Raspberry Pi, 2.9inch, 296×128 resolution, with embedded controller, communicating via SPI interface, supports partial refresh. Compared with normal e-Paper panels, this flexible panel allows bending without being damaged, and it's thinner and lighter. Combined with the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications where curved surface display is required, such as industrial instruments, smart wearable-devices, and so on. Features

Flexible e-Paper, the display section is bendable (DON'T bend the FPC section)

No backlight, keeps displaying last content for a long time even when power down

Ultra low power consumption, basically power is only required for refreshing

Compatible with Raspberry Pi Zero/Zero W/Zero WH/2B/3B/3B+, Jetson Nano

Preserved solder pads for SPI interface, for connecting with other controller boards like Arduino/Nucleo, etc.

Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32)

Specifications

Operating voltage: 3.3V

Interface: 3-wire SPI, 4-wire SPI

Outline dimension: 79mm × 36.7mm × 0.34mm

Display size: 66.9mm × 29.06mm

Dot pitch: 0.227 × 0.226

Resolution: 296 × 128

Display color: black, white

Grey level: 2

Full refresh time: 2s

Refresh power: 26.4mW(typ.)

Standby power: <0.017mW

Viewing angle: >170°

PACKAGE CONTENT 1. 2.9inch e-Paper (D) x1 2. e-Paper Driver HAT x1 3. RPi screws pack (2pcs) x1 4. PH2.0 20cm 8Pin x1