Taidacent 3.5-20V 5A 100W Charging Protection USB Remote Control Controller Smart Home Mobile Phone APP Timing Cycle WiFi Remote Control Switch

Voltage: 3.5~20V Current: 5A Power: 100W Note: extreme high pressure 22v, extreme low pressure 3.0v Feature Timing, Delay, Cycle, Lock/Jog, Share, Firmware Upgrade Supports firmware upgrades for new features Product Application USB night light, USB desk lamp, USB ambient light, USB fan, USB humidifier/aroma diffuser, fish tank light, USB water pump, USB pointing lamp, USB charger and other USB devices; You can also DIY control other non-USB devices by yourself. Please pay attention to use within the range of voltage and current, and leave a margin. FAQ 1. This can be used as long as there is a WIFI hotspot (2.4G). As long as the mobile phone also has a network, the switch can be controlled anywhere. 2. The power-off settings can be maintained. After power-on, it will automatically reconnect and work according to the previous APP settings. 3. It will not work normally after disconnection from the network. It needs to have a WIFI signal all the time, and it will automatically reconnect when there is a network. 4. There are some relatively poor routers, and the long-term link may be disconnected. If the router can be restarted and work normally again, it is the problem of the router. (If you encounter this situation, you can find other routers to test) 5. If the power supply is powered by a power bank, please make sure that the power bank has always output before it can be used, otherwise the power bank will automatically shut down if the standby current is too small. (The working current of the product is about 100MA/0.5W)