Taidacent 12V Touch Switch with Isolation Protection Touch Conrol Touch Switch for Mirror Table LED Lamp DIY Accessories Stepless Touch Control Dimmer Switch

Remarks:Can not connect large-area metal bodies, only small-area metal sheets or glass, acrylic, plastic, etc. (within 6mm thickness). There are two models of this product, one without memory function and one with memory function (Memory function: when dimming to a certain brightness, turn the light off and then turn on the light to remember the brightness of the last light. Note: The memory function is invalid after power off) Features: 1. This switch is suitable for LED lamp with medium (eg glass, acrylic, plastic, ceramic, etc.) lamp body. It can realize touch function under the condition of isolation protection and high safety performance. 2. Touch on and off function: when the human body clicks and touches (touch duration is less than 550ms), the light can be turned on and off. One click to touch, the light is on; another click to touch, the light is off. This cycle. 3. Touch dimming function: When the human body long presses the touch (the touch duration is greater than 550ms), it can realize the stepless brightness adjustment of the light. Once long touch, the light brightness gradually increases. When released, the light brightness stops at the corresponding brightness at the moment of release. If the long press time exceeds 3 seconds, the light brightness will not change after reaching the maximum brightness; long touch again, The brightness of the light gradually decreases. When it is released, the brightness of the light stops at the corresponding brightness at the moment of release. If the long press time exceeds 3 seconds, the light brightness will not change after reaching the minimum brightness. This cycle. 4. It can ensure the safe use of electricity by users, and has a surge absorber, which can effectively prevent the outside world and interfere with the outside world. 5. Wiring method: Red wire and black wire are connected with “+-” 6V-12V input, and red wire is connected with blue wire to load. Yellow touch point