??
FITMENT:
KTM 125/200/390 Duke
??
HOW TO INSTALL: (JUST FOR REFERENCE)
They are easy to install on the rear and front right (smallest bolt) off the bike. The front right fits on to the pre-existing hole with-in the axel. The front left is the tricky part.
In order to get the front left frame slider in, you must take a wrench to the bolt right where it seems like the front wheel is attached. This bolt is not the support rod going across the wheel. The frame slider bolt is the correct size to replace the bolt you just took out.
Front Left - use a wrench to remove the large bolt at the axle (this bolt does NOT hold your wheel in place, it is perfectly safe and easy to remove.). Screw in one of the sliders with one of the larger (6mm) new screws and collar to the same tightness as the bolt you removed . Save the old bolt somewhere in case you ever want to remove the slider.
Front Right - use the smaller new screw (the 5mm one) and its matching collar to screw a slider into the pre-existing threaded hole at the center of the axle. Tighten to about 15 Nm. (Clean the threaded hole with some WD-40 and wipe it clean before screwing this one in, if necessary.)
Back Left - at the rear of the swingarm, there will be two open bolt holes, vertically aligned. Screw one of the remaining sliders into the upper hole (the lower is reserved for a spindle) with one of the remaining 6mm screws and a collar. Tighten to about 15 Nm.
Back Right - same as Back Left.
??
PACKAGE:
4x rubber sliders (black), 3x larger hex screws with matching collars (orange), 1x smaller hex screw with matching collar (orange).
