DFROBOT Gravity MOSFET Power Controller Module as MOSFET Relay or Driver Compatible with Arduino Raspberry Pi and Other Microcontroller

Gravity: MOSFET Power Controller Introduction In most Arduino projects, relays are the first choice to drive some large current device. It requires a certain amount of current to drive the internal coil to pick-up contact. But for some MCU, like Intel Edison, Intel joule, lilypad, Raspberry Pi and other microcontroller with limited amount of current GPIO, it’s hard to drive one or more relays simultaneously. The Gravity MOSFET power controller is a MOSFET relay which can drive a large current device with limited amount of current. Specification VIN Operating Voltage: 5V-36V VIN Operating Current: 0A-20A (Suggest external heat sink when the current over 10A ) Logic Operating Voltage: 3.3~10V Logic Control Signal: 3.3~10V Switching Frequency: 0-1KHz Switching Character: T(on)=20us/T(off)=50us Operating Temperature: -55?-155? Interface Type: PH2.0-3P Dimension: 44*32 mm/ 1.73*1.26 inches Shipping list 1 x Gravity: MOSFET Power Controller 1 x Gravity Digital Sensor Cable