DAOKI 2Pcs Battery Charging Control XY-L10A Module Lithium Battery Charge Controller Protection Board LCD Display 6-60v 10A

Description:
Support Lead-acid battery and Acting Battery, voltage range: 6V~60V;
Can display voltage, percent of battery, charging time at the same time through LCD;
The function is very powerful, realizes the automatic charge control, the control charge time, also may set up and uploads the corresponding parameter through the serial port;

Function description:
1.Automatic Charge control function:
By setting the volt-HI: 'UP' volt-LI: 'dn'; When the battery voltage is below the volt-LI:'dn', the relay leads, the charger begins to charge the battery; when the battery voltage is up to volt-HI:'UP',the relay is disconnected and the automatic charge is completed once;
2. Charge Time Control Function:
After entering the parameter set, set the parameter op is non-zero, then turn on the time control function, op default parameter is:--:--h, the default does not turn on time control function;
After the opening Time control function (OP is non-zero), when the battery voltage is the lower volt-LI'dn', the charger began to charge the battery, the system began to clock; During the timing, the battery voltage ? volt-HI'UP', relay disconnect.
3.Serial data upload and parameter setting function:
The system supports UART data upload and parameter setting
UART:115200, 8, 1
Cmd Func
on Relays enable to open
off Relays disable to open
start Start data upload
stop Stop data upload
read Read the param setting
dw10.0 Set volt-LI:'dn'
up20.0 Set volt-HI:'UP'
xx:xx Set the charge time OP
00:00 stop charge time
Data Upload message Format:
Battery voltage + battery percent + charge time + charge status 12.0V, 020%, 00:10, OP

Package includes:
2 x Battery Charging Control XY-L10A Module