Arkare 16 4ft WS2812B Addressable Digital RGB LED Strip Pixels Lights 5m 300 LEDs Programmable Dream Color LED Ribbon Light Waterproof IP65 DC 5V Support Arduino Raspberry Pi No Power Controller

Technical Specs: IC type: WS2812B Light source: 5050 RGB LED LED Qty: 60 LEDs per meter, 300 LEDs per roll 1 integrated RGB LEDs per segment, individually controllable R G B order: G/R/B; NOT R/G/B Wave length (NM): R,620~625nm ; G,515~525nm; B,465~475nm The gray level: 256 Color: 24-bit full color Beam angle:120° Voltage: DC 5V Max Current: 3.6A per meter, 18A per roll Max Power: 18W per meter, 90W per roll Protection level: Waterproof IP65 Dimension: 10mm (0.39") wide, 3mm (0.12") thick with coating on, 16.7mm (0.65") long per segment, 5000mm (196.85”) long per roll. Connector: 3-pin JST SM Connector PCB color: White Life span:?50000hrs Working environment: -20?to +50? Red wire~5V+; Black Wire~GDN; Green wire~Data Reverse polarity protection Hot swap protection Kindly Note 1.Only 1x WS2812B LED strip in the package. To let it work, you need buy 5V power supply and WS2812B controller, which is not included. 2.You must use a 5V DC power supply to power these strips, do not use higher than 6V or you can destroy the entire strip. 3.If you set the whole roll of LED strip on full white, it will get orange/ red gradually. This is not quality issue but voltage drop. To solve this issue, you need to inject 5V power on both ends of the LED strip. 4.The strips are made of flexible PCB. You can gently bend it to an arc. But please NEVER rudely bend it to right or acute angle, otherwise the circuit board will crack. Package 1x 16.4ft WS2812B led strip 1x 3PIN JST connector Power supply and controller are not included