Acxico 1Pcs DCDC Step Up Power Supply Module 600W 12A DC Boost Voltage Converter 1260V to 1280V Regulator Booster Module

Specifications: Output power: = Input voltage * 10A, such as: input 60V * 10A = 600W,if need more output power, such as need the output to 15A,two modules can be used in paralle, the current of each module can be adjusted to 8A. Output feeding back protection:Yes (for charging,the separate output diode is not required.) Installation: two 3mm screws Connection: terminals, solderless Module Weight: 205 g Note: Be sure to energize the module before using it, and then connect the load, which is especially important in high-power loads. The input voltage should be stable, especially if some low-voltage (12V) input power supply is connected to the load voltage and will drop below 10V, which is easy to break down the power tube. The input voltage should avoid the upper and lower voltages as much as possible to avoid damage to the module caused by voltage fluctuations. The insurance is burned, don't take the insurance again, power on the test, you must eliminate the cause before you can power on, usually caused by power tube breakdown. Do not use a short-circuit load to regulate the current. More than two modules cannot be used in parallel with both input and output, otherwise the current limiting function will be disabled. The voltage difference between input and output is not suitable for too small, otherwise the constant current function is not guaranteed. For example, some friends use 12v battery to boost to 14v, charge 12V battery, the current is too large, resulting in insurance burned. The module and voltage are normal, but some laptops can't be charged and used. This is not a quality issue, because today's computers have an identification function that may refuse to use a non-original charger. Package Includes: 1pcs