Description: The SHT31-D
sensor has an excellent ± 2% relative humidity and ± 0.3 ° C accuracy for most uses.
Unlike earlier SHT sensors, this sensor has a true I2C interface, and
(bonus!) Even with two address options. It also is 3V or 5V
compliant, so you can power and communicate with it using just
about any microcontroller or microcomputer.
Power Pins: Vin-this is the power pin. The chip can use 2.5-5VDC for power.
To power the board, give it the same power as the logic level of
your microcontroller-eg for a 5V micro like for Arduino, use 5V.
For a 3.3V controller like a Raspbery Pi, connect to 3.3V
GND-common ground for power and logic
I2C Logic pins: SCL-I2C clock pin, connect to your microcontrollers I2C clock line.
This pin has a 10K pullup resistor to Vin
SDA-I2C data pin, connect to your microcontrollers I2C data line.
This pin has a 10K pullup resistor to Vin
Other Pins: ADR-This is the I2C address selection pin. This pin has a 10K pull
down resistor to make the default I2C address 0x44. You can tie
this pin to Vin to make the address 0x45
RST-Hardware reset pint. Has a 10K pullup on it to make the chip
active by default. Connect to ground to do a hardware reset!
ALR-Alert / Interrupt output. You can set up the sensor to alert you
when an event has occured. Check the datasheet for how
you can set up the alerts
Specification: Material: PPS, Metal
Output: IIC
Supply Voltage: 2.4-5.5V
Energy Consumption: 4.8uW (Low repeatability, 1 measurement per second)
Operating Temperature Range: -40-125 ° / -40-257 °
RH Working Range: 0-100% RH
RH Response Time: 8 seconds (?63%)
Size: app.1.1 x 1.3cm / 0.43 x 0.51in
Package includes: 1 x SHT31-D Temperature Humidity Sensor Module
1 x Pin Header
Ziekk SHT31 SHT31-D Temperature Humidity Sensor Module Microcontroller IIC I2C Breakout Weather 3V 5V Compliant for Arduino
Was:
$41.08
Now:
$20.54
- SKU:
- O436084
- UPC:
- 190431011932
- Condition:
- New
- Availability:
- Free Shipping from the USA. Estimated 2-4 days delivery.