Yellow HTV Iron on Vinyl 12Inch by 10ft Roll PVC HTV Yellow Heat Transfer Vinyl for T-Shirt HTV Vinyl Roll for Criut, Easy to Cut and Weed for Heat Vinyl Design

*Operation instructions 1.Choose your desired design , Cut with the gloss side facing DOWN and the duller back of the vinyl facing up. 2.Cut it onto the vinyl sheet with a craft cutter. *Settings may vary based on blade condition and age of machine. 3. Weed out the excess . 4. Heat and Transfer : Place the sheet with your design on to your shirt. Home Iron:Please Heat the iron on medium setting (302°F– 320°F),Press each section of the design with medium/firm pressure for 10-15 seconds; Heat Press?Preheat garment for 2-3 seconds; Apply design at 305?; Use medium pressure for 10-15 seconds. 5.Cold peel / Hot peel.Peeling the clear pet film after the vinyl turns cold, just in 15-30 seconds later for the vinyl to cool down. *If any part of the iron on vinyl lifts off, repeat the steps above until you can peel off the clear backing without lifting up the vinyl. *Warm Tips 1.Make sure there are no wrinkles on the material. 2.If you are having trouble, try turning the shirt 90 degrees and pressing again, this should eliminate problems from cold spots. 3.If you've already ruined one shirt, keep using it to experiment. Cut small pieces of heat transfer and try raising or lowering your temperature, or pressing longer or for less time.