YEE PIN 2017 2018 CR-V EX EX-L Touring 7 Inch Vehicle Navigation Glass Toughened Film Control Navigation Display Film

About the installation of protective film: 1. Clean the screen with the provided alcohol prep. Then clean wet area with the provided micro fiber cloth. It is important to remove all dust and debris from the screen. 2. Remove the glass screen protector from packaging. Now, put the suction cup on the top right corner of the front side of your glass screen protector. Make sure it has a good suction. 3. Peel the film off the back of the screen protector and do not touch the glue on the back. Hold the edges with one hand and the suction cup with the other. (Before this step it would be a good idea to see if the product has been cut to fit your screen. 4. Slide the volume knob through the only hole in the glass screen protector. 5. Two ways to do this step. What I did was: line up the screen protector with your car screen and use the suction cup to start installing your glass screen from the right to the left. It should look like a smooth wave that the screen protector attaches itself from the right side to the left. If you start at the right and the glass screen protector starts gluing from the left or middle, you will get air bubbles under your screen. Second way: Insert volume knob through hole, line up the landmarks and push down on the left side to start the attaching process on the left side. Hold up the right side of the glass screen protector with the suction cup and make sure it attaches like a smooth wave from left to right. Service: If our product has any issues, please don't hesitate to contact us for a quick solution.