WTKSOY New 2 PCS SG214008 Rear Hatch Liftgate Tailgate Lift Supports Struts Gas Springs Shocks fit 1987-1995 Jeep Wrangler

WTKSOY is committed to bring you the consumer, the ease and comfort of finding the part you need. Backed by a strong Technical Support , we'll take care of your needs and do the research needed to find that hard to find item. Specifications: You will receive 2pcs New Rear Left+Right Liftgate Lift Supports for following vehicles. 1987-1995 Jeep Wrangler With Factory Hardtop Models(Excludes Aftermarket Top) Interchange Part Number:SG214008; 4782; WGS-211; LSC-0211; 8195310; 8195629; 10660; 8436IR; 72223; G0004296; 55000630; 55027180; 8955000630; 901114; Package Includes: 2pcs x Rear Lift Supports. How to install : 1. Use Safety stands whenever a procedure requires you under the vehicle or supports. Or have someone hold the lid open for you so that they can raise or lower it as needed. 2. Before removing the old lift support, inspect the end connections and compare them to the units on your vehicle to make sure that they are the same As well as the extended length. 3. Remove the old support from the vehicle by placing a small flat headed screw driver under the U shaped band on the ends of the support. Slowly turn the screw driver and it will lift up on the band approx.1/8", then pull the support away from the vehicle and it will release. 4. To install the new supports do the same procedure in reverse. DO NOT jam the new support end over the ball socket without lifting the U band slightly or damage may occur. 5. Lift Supports need to be installed fully extended. In most cases you just can't compress them unless they are on the vehicle. If you have any issues during the installation PLEASE contact us. Never force a support. 6. If the ends are not lining up the support may need to be turned. To do this attach the shaft end of the support to the vehicle and then turn the entire body of the support clockwise unit the ends line up.