WSDMAVIS 1 Pcs Digital Timer Relay DC 12V 240W Time Delay Relay Module Delay Controller Board with LCD Display

Instructions: Short press the SET button once to enter the time setting mode, the red digital tube flashes, press the button to increase or the button to adjust the timing time T1, T1 is set again shortly press the SET button, the green digital tube flashes, and the timing time is set by the button plus or minus. After the T2 and T2 time are set, short press the SET button again, the system will automatically save the memory setting time or wait for 6s, and the module will automatically save the data after 6s. Long press SET to enter the parameter setting mode. There are two sets of parameters for users to choose P0 and P1. In the current mode, short press SET to switch between P0 and P1. Under the PO parameter, you can set the timing mode that suits you by pressing the button plus or minus. Under the P1 parameter, the working mode can be set by adding or subtracting buttons. P0-0: T1 timing time mode is seconds P0-1: T1 timing time mode is minute P0-2: T1 timing time mode is when P1-0: The relay is closed after delaying T1 time (T1 timing) P1-1: The relay is released after a delay of T1 time (T1 timing) P1-2: After delaying T1 time, the relay is closed (T1 timing), and then after delaying T2 time, the relay is released (T2 timing), and it ends. P1-3: The relay is released after a delay of T1 time (T1 timing), and after a delay of T2, the relay is closed (T2 timing), and it ends. P1-4: The relay is closed after a delay of T1 time (T1 timing), and after a delay of T2, the relay is released (T2 timing), and the cycle is repeated. P1-5: The relay is released after a delay of T1 time (T1 timing), and then after a delay of T2, the relay is closed (T2 timing), and the cycle is repeated.