Description:
The washer drain pump sits at the back of your washer and pumps water out during the drain cycle. When this part's propeller or motor goes bad or the body cracks, your washer won't drain properly and can even leak. This Seentech washer drain pump replacement is an affordable high-quality exact equivalent to part number W10536347.Works with most top name brands:
Whirlpool, Kenmore, Maytag.Works with the following models:
Maytag 7MMVWB850WL0, MTW6300TQ0, MTW6300TQ1, MTW6400TQ0 Kenmore 11027032600, 11027032601, 11027032603, 11027042602, 11027042603 Whirlpool 7MWTW7800XW0, MTW6500TQ0, MTW6600TQ0, WTW6200SW0Replaces part numbers:
2392433, 8542672, AP5650269, W10049390, W10155921, W10217134, W10281682, W10536347.Instruction when replacement:
The tools needed for this repair project is a putty knife, Phillips and flat blade screw driver, 1/4 inch nut driver, and needle nose pliers. Remember to unplug washing mechine from power source as a safety precaution. Refer to the manual provided by the manufacturer for further installation instructions. 1. Disconnect all electrical & hydraulically net work for washing machine. 2. Empty all contents and also any inner water. 3. Disassemble the defective drain pump from impeller/filter/machine shaft include the electrical & Hydraulically connection. 4. Install with carefully at the same place the new Drain pump motor with also new gasket, the eventual bracket and protection for water. 5. Shut the screws to avoid clasp excessively so that not ruin the threads. 6.Repair the electrical & hydraulic connection for the drain pump, by verify and supervise the correct working of the machine, executing a washing-drying cycle.A new washer drain pump can fix them:
- Washer will not drain - Washer pumps but won't spin - Noisy cycles - Washer leaks
