DROK DC 4.5-100V 0-50A Volt Amp Display Meter
Parameters:
Voltage Measuring Range: DC 4.5-100V
Voltage Resolution: 0.01V under 10V; 0.1V between 10V and 100V
Current Measuring Range: 0.0-50.0A (If the current is higher than 20A, a shunt is required, or the meter will burn)
Current Resolution: 0.1A
Display: 0.39" LED dual display
Measuring Rate: ?500mS/time
Measurement Accuracy: 1% (±1 digit)
Opening Size: 68*38mm
Dimension: 70*40*30mm
Shunt: 50A/75mV
Extreme Working Condition:
Working Temperature: -10??+65?
Working Humidity: 10?80% ( No Condensation)
Working Air Pressure: 80?106kPa
Sunlight: No direct exposure
Connecting Method:
COM: Common terminal of power supply negative pole
V+: Positive pole of tested voltage, positive pole input terminal of power supply
A+: Positive pole input terminal of tested current ( This meter adopts common-ground design that earth wire of measuring terminal is interlinked with earth wire of power supply,
so A+ can only be connected between the tested device negative pole and power supply negative pole. The meter will burn if connected wrong.)
Note: If the meter is used as voltmeter, it is suggested that the yellow wire and black wire are connected together.
Note:
If the current cannot display properly, please check whether the wires are connected correctly.
If you are not sure of the wiring method, please feel free to contact us.
Package Included:
1x Voltage Current Display
1x 50A/75mV Shunt
Parameters:
Voltage Measuring Range: DC 4.5-100V
Voltage Resolution: 0.01V under 10V; 0.1V between 10V and 100V
Current Measuring Range: 0.0-50.0A (If the current is higher than 20A, a shunt is required, or the meter will burn)
Current Resolution: 0.1A
Display: 0.39" LED dual display
Measuring Rate: ?500mS/time
Measurement Accuracy: 1% (±1 digit)
Opening Size: 68*38mm
Dimension: 70*40*30mm
Shunt: 50A/75mV
Extreme Working Condition:
Working Temperature: -10??+65?
Working Humidity: 10?80% ( No Condensation)
Working Air Pressure: 80?106kPa
Sunlight: No direct exposure
Connecting Method:
COM: Common terminal of power supply negative pole
V+: Positive pole of tested voltage, positive pole input terminal of power supply
A+: Positive pole input terminal of tested current ( This meter adopts common-ground design that earth wire of measuring terminal is interlinked with earth wire of power supply,
so A+ can only be connected between the tested device negative pole and power supply negative pole. The meter will burn if connected wrong.)
Note: If the meter is used as voltmeter, it is suggested that the yellow wire and black wire are connected together.
Note:
If the current cannot display properly, please check whether the wires are connected correctly.
If you are not sure of the wiring method, please feel free to contact us.
Package Included:
1x Voltage Current Display
1x 50A/75mV Shunt
