With English manual and all compomnents, it is very great for teaching electronics projects, learning electronics, or just training your solder skills
Please note that the soldering project needs basic electronics knowledge.
Install Steps 1?Install circuit1.1>. Solder the resistors, 8-pin IC holder, switch, potentiometers, transistors, electrolytic capacitors and the 5mm RED light-emitting diodes successively on the circuit board according to the identifiers on the circuit diagram and board.
1.2>. Pay attention to the direction of IC Socket. In addition to facilitate debugging, don't install IC LM393 yet.
1.3>. Install Mecanum wheel
1.4>. Install photoresistor
1.4>. Install photoresistor and white LED on PCB reverse.
1.5>. Install battery case.
1.6>. Test.
2?Install mechanical parts:
2.1>. Install the four gaskets on the circuit board.
2.2>. Insert a steel shaft from the center hole of the wheel.
2.3>. Put a three-way sleeve into steel shaft, installed in place.
2.4>. Place a gear into the steel shaft in the center of the steel shaft.
2.5>. Put a three-axis sleeve into the end of the steel shaft.
2.6>. Finally, the two shafts on the steel shaft are fitted into the screw projections of the fixed washers.
2.7>. Install Motor.
3?Power on, Test. Install LM393.
Well package and high quality customer service also help a lot.
Are you interested in this 2 pack smart car kits? Scroll up and add it to cart now!