USB UART CableUSB to TTL Serial Adapter Cable 5v Minnowboard with 6 Pin 01 inch Pitch Female Socket Header UART IC FTDI Chip 6ft18m Logic Level 50V

6-Foot FT232RL FTDI USB to TTL serial adapter cable for 5V logic level serial communication NOTE: If any installation or usage issues, please email us or you may download a driver and usage guide on FTDI official website The original FTDI chip is embedded in the USB-A end; 6 way 0.1” header connector with VCC (5V power) and GND (ground), as well as RXD, TXD, RTS and CTS at 5 V logic level. Applications: Upgrading Legacy Peripherals to USB Interface Microcontroller UART or I/O, FPGA / PLD to USB Replace MAX232 type level shifters allowing for direct connection of products to PC Industrial Control / USB Software / Hardware Encryption Dongles Features - The I/O pins of the FTDI wire are configured to operate at 5.0V logic level - Entire USB protocol handled by the electronics in the cable; - UART interface support for 7 or 8 data bits, 1 or 2 stop bits and odd / even / mark / space / no parity; - Data transfer rates from 300 to 3M baud rate at TTL levels; - Fully assisted hardware (RTS#/CTS#) or X-On / X-Off software handshaking; - Internal EEPROM with users writable area; - Supply voltage comes from USB bus, no external supply required; - UHCI / OHCI / EHCI host controller compatible Note: Driver free for Windows 7/ 8/ 8.1/ 10 system, when the pc connect the Internet, it should auto detect and install the driver. For other systems, you should download the drivers from FTDI official site. FTDI drivers download link: http://www.ftdichip.com/Drivers/VCP.htm Driver installing guide: http://www.ftdichip.com/Support/Documents/InstallGuides.htm