Before purchasing a copy remote control, please confirm that your remote control meets these three conditions:
Condition I: the original remote control may be used normally.
Condition II: frequency of original remote control is 433Mhz.
Step 1 : Clear codes
Press the A button and B button at the same time, after the LED indicator light flashes three times, loosen any one of the buttons while the other is kept pressing, then push the released button three times, the LED indicator will enter into the fast flashing status. At this time all the memory data is cleared, the cleaned remote control will not have lighting LED indicator no matter which button you press.
Step 2: Copy method
One hand keeps the original remote controller, while another keeps the copy remote control, the two remote controls should be placed as closely as possible (the ideal situation is to put the two remote controls on the desktop side by side with zero distance), respectively press down the copy button, when the LED indicator light flashes quickly after three flashes, this copy is successful, other key operating methods are the same. Some remote control has a smaller transmitting power, so the original remote control should be placed back to back the copy remote control to be operated. For the presence of noise, it should avoid interference to operate, If the copy is not successful, it should recopy after clearing code.
Resume/Recovery Code
If you clear code of duplicating remote control incautiously, you can press Button C and Button D at the same time, the LED Indicator Light flash fast. It means that the code of duplicating remote control is resumed.
Support Coping the following Codes: PT2262 PT2264 PT2260, PT2240, PT1527, SC2262, SC2260, EV1527, SCT527, HS1527, HS2240, SCL1527, FP1527 HS2262 HS2260 LX2262 LX2260 EV1527 encoding chip(With this remote duplicator you can clone al