This remote controller is designed to separately control your ceiling fan speed and fan Off and dimming for the incandescent lights.
1.SETTING THE CODES
This unit has 16 different code combinations. To set the codes, perform the following steps:
A.Setting the codes on the transmitter:
a.Remove battery cover. Press firmly on the arrow and slide battery cover off.
b.Slide code switches to your choice of up or down position. Factory setting is all up. Do not use this position.
Use a small screwdriver or ball point pen to slide firmly upor down (Figure 1).
B.Setting the codes on the receiver:
a.Slide code switches to the same position as set on your transmitter (Figure 2)
b.Replace battery cover on the transmitter.
WARNING:HIGH VOLTAGE!
Disconnect power by removing fuse or switching off circuit breaker.
Do not use with solid state fans.
Electrical wire must meet all local and national electrical code requirements.
Supply for fan must be 110/120 volt, 60Hz.
Maximum fan motor amps: 1.0,
Maximum light watts: 300 incandescent only.
Otherwise power can cause serious injury or death.
NOTICE !
Your ceiling fan and light kit assembly must meet the following requirements:
1.Do not use with solid state fans.
2.Electrical rating: 120v 60Hz 3.5
AMAX. Motor amps: 1.0
MAX. Light watts: 300-(incandescent only)
Package Includes:
1 x Ceiling Fan Remote Control
1 x Handheld Remote Receiver
2 x Screws6 x Wiring caps
1 x User Manual