U/D Dent Car Puller, Dent Repair Puller,Paintless Dent Repair Kit for Car Auto Body Hail Damage Remover with Glue Tabs

How to use this paintless dent repair kits:(Glue not included) 1.Clean the dent with a clean wet cloth 2.Mount the glue stick into the glue gun, pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes 3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is) 4. Pull the trigger and apply the drawing gasket with extruded glue 5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter) 6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent 7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen 8. Clean the repaired place with a clean wet cloth Dent puller operation skills 1. The gasket should be stuck to the bottom of the concave, not to the concave wall, otherwise it is easy to come unglued. 2. The gasket can not tilt pull, otherwise it is easy to come unglued. 3. If the dent is large, do not stick the gasket directly in the middle of the dent, but from the concave edge to the middle of the operation. Dent puller adhesive skills 1. Power on the glue gun and heat the glue stick fully. After melting, drop the glue on the gasket and stick to the car body quickly, because the solidification time of the glue is very fast. 2. Blow the sheet metal with a hair dryer to keep the temperature of the sheet metal, immediately stick the gasket coated with glue, and wait for about five minutes to operate. Package List 1 * Dent Remover Repair Tool 18* Glue Puller Tabs