Fit for:
2003-2011 Ford E150 E250 E350
2007-2014 Ford Edge
2001-2014 Ford Escape
2002 Ford Escort
2000-2005 Ford Excursion
1998-2014 Ford Expedition
1998-2014 Ford Explorer
2001-2010 Ford Explorer Sport Trac
1998-2014 Ford F150 F250 F350 (also Super Duty)
2004-2007 Ford Freestyle
1998-2011 Ranger
1998-2003 Ford Windstar
2006-2008 Lincoln Mark LT
1998-2003 Lincoln Navigator
1999-2009 Mazda B2300 B2500 B3000 B4000
2001-2011 Mazda Tribute
2005-2011 Mercury Mariner
2004-2007 Mercury Montery
1998-2010 Mercury Mountaineer
Steps:
1.Close all doors, then open driver's door and press the Unlock button on driver's door while it is open and insert key into the ignition.
2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (if the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1)
(Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
3. Within 10 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5.
4. Within 10 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 4 for all other remotes.
5. Turn ignition to OFF. Locks will again cycle to indicate the end of programming mode.
*If this does not work try the procedure with the door closed.
2003-2011 Ford E150 E250 E350
2007-2014 Ford Edge
2001-2014 Ford Escape
2002 Ford Escort
2000-2005 Ford Excursion
1998-2014 Ford Expedition
1998-2014 Ford Explorer
2001-2010 Ford Explorer Sport Trac
1998-2014 Ford F150 F250 F350 (also Super Duty)
2004-2007 Ford Freestyle
1998-2011 Ranger
1998-2003 Ford Windstar
2006-2008 Lincoln Mark LT
1998-2003 Lincoln Navigator
1999-2009 Mazda B2300 B2500 B3000 B4000
2001-2011 Mazda Tribute
2005-2011 Mercury Mariner
2004-2007 Mercury Montery
1998-2010 Mercury Mountaineer
Steps:
1.Close all doors, then open driver's door and press the Unlock button on driver's door while it is open and insert key into the ignition.
2.Turn ignition from OFF to RUN 8 times within 8 seconds, with the 8th time ending in RUN. Door locks will cycle to confirm programming mode. (if the door locks do not cycle, then it was done incorrectly. You must start over by removing key and beginning from step 1)
(Off is the position where you can remove your key, RUN is the position just shy of starting your car.)
3. Within 10 seconds press any button on the first keyless remote to be programmed. Door locks will cycle to confirm programming. If you only have one remote then skip to step 5.
4. Within 10 seconds, press any button on the second keyless remote. Door locks will cycle again to confirm programming. Repeat step 4 for all other remotes.
5. Turn ignition to OFF. Locks will again cycle to indicate the end of programming mode.
*If this does not work try the procedure with the door closed.
