Titan 23140 0-80 in/lb & 0-7 Newton-meter 1/4 Drive Beam Style Torque Wrench

1/4" Dr. Beam Type Torque Wrench 23140 • 0-80 In/Lbs (0-9 Nm) • To ensure accuracy, verify that the pointer is aligned with the "0" calibration mark. • The torque beam must float above the scale and not touch the scale at any point. • If needed, the torque beam can be repositioned by gently bending back into place. • Before attaching torque wrench, hand tighten fasteners until snug. • The handle of the torque wrench should be held between index finger and thumb applying force to the center of the handle. • Turning motion should slow as resistance increases and stop once the desired torque measurement is met. • Torque measurements must be read from directly above the pointer. Do not read measurements from an angled position. • For better accuracy, torque measurements should be met while the fastener is in the turning motion.