T Outliner Blades for Andis T Outliner, Andis GTX, T Outliner Replacement Blade Andis GTX Replacement Blade -Ceramic T Blade plus Gold Steel Blade-

BESTBOMG Advanced Ceramic T Blade with 4 Snap on Combs  Attachment Set FIT MODEL? Fits for Andis Blackouts Fits for Andis GTX GTO Fits for Andis T-outliner Fits for Andis T-outliner Cordless Benefits: Advanced ceramic technology makes our ceramic blade 5X sharper  Lasts 5X longer Stays 5X cooler LONG LASTING: Made from a high-tech ceramic material to stay sharper longer. Heat resistant for a cooler and more comfortable cutting. EASY INSTALLATION: This replaces the small moving cutter blade. Can also be used to upgrade steel blades to ceramic blades. ACCURATE HAIRCUT: Comes with 4 snap on limit combs, you can freely and accurately trim the hair length you want. Warm Tips: Install and adjust 0 gap for the blade 1.Use screwdriver, Remove the screw from the trimmers. 2.Install the Plate and put metal gasket on the top. and don not tighten the screw, Leave a little space for the plate. So the plate can move up and down. Which can enable the moving blade more closely to the guide blade. 3.Make the moving blade towards to the guide blade. Then you need a flat surface, to lay it flat, make a little bit angel for guide blade, like 10 degrees, so the moving blade is a little bit underneath the guide blade. From that angle, tighten the screws. Then you don’t cut yourself, because the moving blade is very sharp. 4.Check if it is ok. Use your finger cross the blade, if it is smooth, the adjustment is OK. If it was rough, which means the moving blade was higher than guide blade, you need make more several time to try it out. 5.Reattach the blade, and tighten the screws.