Supercrazy Engine Injector Removal Puller Kit Car Repair Garage Installer Tools for AUDI SKODA SF0053

SAFELY REMOVE INJECTORS: Get the job done right with the Slide Hammer Adapter Injector Puller Tool 18-Piece Set; This injector installer & puller set allows you to remove, install, and service FSI or TSI injector reseals. FITS YOUR VEHICLE: Fuel injector tool for petrol injectors found in gasoline direct injection vehicles with 1.4, 1.6, 1.8, 2.0, 2.7, V6, 3.0, V6, 3.2 V6, 3.6 V6, and 4.2 V8 FSI engines; Is compatible with Seat, Skoda, and similar European vehicles engines; Not intended for diesel engines. EASY TO USE: Select a puller attachment, slide it onto the injector, use puller screw or slide hammer to safely remove injector; Once injector is pulled, remove old seal using a small pick or flathead screwdriver (not included) carefully to not damage injector groove surface; To fit the new seal, place included assembly cone on tip of the injector and slide new seal onto assembly cone, use included assembly sleeve to slide seal onto injector; Additional tools included for cleaning and installing. PACKAGE CONTENTS: A: Ball type insertion adaptor. B: Injector puller large cup type for FSI type injectors.23mm x 76mm. C: Injector puller small cup type for FSI type injectors.14mm x 40mm. D: Injector puller two leg (thin) for FSI type injectors.19mm x 20mm. E: Two cylindrical adaptors. 12mm I.D. 13mm I.D. 40mm long. F: Two tapered cone adaptors. 27mm x 4mm taper, 35mm x 7mm taper. G: Three knurled stepped adaptors 24mm. H: One threaded cup type pulling adaptor. 15mm x 10mm. I: One threaded cup type pulling adaptor. 10mm x 8mm. J: One spacer bush 19mm O.D x 12mm I.D. x 12mm long. K: Slide hammer puller L: Disconnect key 9.5mm.