STARPOWERY Wi-Fi Range Extender Wifi Booster and Signal Amplifier Wifi Router Extender with Ethernet Port Wireless-N 802.11n b g Router 300Mbps

How to use it? 1. Plug this in wall socket 2. Type Default Ip address :192.168.10.1 or ap.setup in the browser bar which will automatically direct to a set up page 3. Enter User&password:"admin" by default 4. Select the one that you want to extend and input the password of the wireless network 5. Wait for the device to reboot and reconnect to wifi using the new SSID 6. Then you could use the wifi extender NOTE: It can not improve the internet speed, just the coverage. FAQ Why the mode is setting unsuccessfully ? A. You may have typed in the router's wireless password incorrectly, please log in and check the wireless password without over 32 characters under 2.4ghz B. The wifi repeater maybe out of range(less than 30ft), please move it closer to the router C. Please reset the wifi repeater and go through the configuration again Note: when finish setup, let the wifi repeater buffer 2 minutes Why can not see the login page after entering http://192.168.10.1 in the browse? A. Make sure your computer is connected to the Wifi Repeater network B. Make sure your computer is set to: obtain an IP address automatically DHCP How do I reset the Wifi Repeater? Press and hold the reset button for about 8 seconds. Package Contents 1x Wi-Fi AP/Router 1xRJ-45 Networking Cable 1x Quick Installation Guide