[Sintron] 40Pin GPIO Extension Board Starter Kit + Micro Servo SG90 Sidekick LED Thermistor Temperature Sensor Breadboard for Raspberry Pi 1 Models A+ B+ Pi 2 3 Model B and Pi Zero

Overview

After you got your Raspberry Pi 2 Model B 1GB & B+, you might have enjoyed the open source function and code, but don't forget this, they are also able to interact with external hardware as embedded system. so get this kit, and start it! we also provide pdf files about how to control them. you will have much fun for doing this!

This 40Pin GPIO Extension Board is already soldered and assembled. so buyer just need to plug it in, then there you go!

The Raspberry Pi B+ has landed on the Maker World like a 40-GPIO pinned, quad-USB ported, credit card sized bomb of DIY joy. And while you can use most of our great Model B accessories by hooking up our downgrade cable, its probably a good time to upgrade your set up and accessorize using all of the Model B+'s 40 pins.

That's why we now carry the Sintron GPIO Board Plus with Color 40 Pin Ribbon Cable for Raspberry Pi B+.

Package List Includes :

(1) 330 Ohm Resistor x 10
(2) 1k Ohm Resistor x 10
(3) 10k Ohm Resistor x 10
(4) 5mm RGB LED x 1
(5) 5mm Red LED x 10
(6) 5mm Green LED x 10
(7) Electrolytic Capacitor x 5
(8) 10nF Ceramic Capacitor x 10
(9) 100nF Ceramic Capacitor x 10
(10) Active Buzzer x 1
(11) Jumper Cable Wires x 65
(12) Rectifier Diode x 1
(13) Tilt Sensor/Switch x 1
(14) Vertical Slide Switch x 5
(15) 6x6x4.3 Push Button x 5
(16) Thermistor Temperature Sensor x 1
(17) Tower Pro Micro Servo 9g (SG90) x 1
(18) Potentiometer(Adjustable Resistor) x 1
(19) 400 Tie Points Solderless Breadboard x 1
(20) Light Dependent Resistors(Light Sensor) x 1
(21) New 40-Pin GPIO Extension Board x 1
(22) 40-Pin GPIO Ribbon Cable for B+ & Pi 2 x 1