Simpeak 2-Pack Compatible for Apple Watch Screen Protector 38mm, [3D Full Coverage][Bubble Free] [Anti-Scratch] [Anti-Fingerprint] Tempered Glass Screen Protector for iWatch 38, Black

Apple Watch Screen Protector Instruction: 1.Take out your watch and remove the strap. Use the alcohol wet wipe to clean the screen completely first, then use dry microfiber wipe to clean again, make sure that nothing left on the screen, like remaining lint or any dust. 2.Peel off the protective film from invisible shield, DO NOT touch the exposed surface(take it with two fingers on the edges) 3.Align the invisible shield and put it on the screen(do not press down, just align first), check if all the gaps between four edges of watches and invisibleshield are the same. If not, move the invisibleshield slightly by taking it with fingers on the edges till all the gaps are the same. 4.Take the Bubble scraper on the bottom part one hand, so that it gets more strength. Fix your watch with the other hand. Use the Bubble scraper to press the invisibleshield down on the screen from one side to the other side, pushing out any air and making all the air inside disappeared. 5.If there is any air on the screen edges, it is because the edges of invisible shield are closed with screen which makes air not able to be pushed out. Please do as below: lift the edge where has air around of invisible shield till the air inside touches the air outside(the air inside will disappear after lifting), then press the shield down on the screen and push out the air again, till all the air disappear. If not able to make the air gone, please redo step5. 6.Check your screen make sure all the air disappeared. Use the Bubble scraper to press the invisible shield from center to edges in order to avoid air goes inside again because of loose edges. 7.Within 24 hours after finish 7steps, if air shows up again, please repeat step 5 6 7. Till no air shows up within 24hours. 8.As the invisible shield sticks to screen longer, it would get stickier.