Easy to use:You can adjust the voltage by placing a multi-meter on the output, at the same time using a precision screwdriver to adjust the potentiometer. It can be minute adjustments to achieve a precise voltage(clockwise buck , counterclockwise boost).
Application:
Widely used in DIY mobile power supply, monitoring, children's car, camera, vehicle, communication equipment?SIM808 GPRS? 5vdc computer fans?reverse camera needed 3.3V?drone, circuit board, MCU projects, LED strips, water cooling pump, ESP8266-01S ?Arduino projects?Raspberry Pi?etc.
Specifications:
Type:Non-synchronous (Buck)
Input voltage: 4.5 V to 28 V
Output voltage: 0.8 V to 20 V
Output Current: 1.8 A typical (3.0 Max)
Conversion efficiency: 96% (maximum)
Output ripple: less than 30 mV
Switching frequency: 1.5 MHz (highest), typically 1 MHz
Operating temperature: 49? to 185?
Diameter of through holes?0.047"
Weight: 0.07oz
Size: 0.87"x0.67"x0 .16"
Package Include:5 xMP1584EN DC-DC adjustable buck converter.
Attention:
1.Do not reverse the positive and negative terminals to avoid any possible damage.
2.Do not use light load (less than 10% of output power) or without load,put at least a 300mA load on it, no less.
3.The input voltage must be higher (at least 3V) than output,No boost!
4.The Diameter of through holes is 0.047", so it doesn't fit in a breadboard.
5.There is only a single input with two holes for each positive and negative,but it is not two separate inputs.