Seanme Driveway Alarm Wireless Outside Weatherproof, 328 ft Long Range Wireless Outdoor Driveway Sensor Alert, 1 Alarm and 2 Waterproof IP65 PIR Motion Detector

Never worry about surprise visitors again with seanme Wireless Driveway Alert

This easy to use and set up, wireless Infrared Motion Sensor Door Bell Alarm includes 1 Receiver and 1 Sensor Bright LED indicators and a choice of 38 Chimes allowing you to customize your alerts.

Specifications

1. Working Voltage of the Receiver: 110V-240V
2. Working Voltage of the PIR Sensor: 4.5V ( 3 AAA batteries)
3. Working Range: Up to 328 feet (100 meters)
4. Infrared Sensing Range: Up to 23 feet (7 meters)
5. Waterproof: IP65
6. Receiver Switch Settings:

• Music source: 38 different songs
• Volume Adjustment: high, middle, low

USE

1. Once installed after 30 seconds the unit can detect motion. Once detected it will send a signal to the receiver The LED lights will flash and it will chime your selected ringtone.
2. Allow 15-30 seconds to reset between chimes.
3. Choose the installation position that is available for the rectangle compartment mount the compartment into the required position by using screws, get the two angles of the groove of the round parts mounted at the back of the sensor; then push the rectangle compartment into the round part.

Care and Maintenance

1. Please keep the detector & receiver in sheltered places to avoid contact of both units from water and direct sunlight Heavy storms & snowfalls, it is recommended that the unit should be moved indoors or to a safe place.
2. When the LED indicator does not go on the battery power is either low or dead. At that time, you should change the batteries.
3. Clean the detector regularly with a damp cloth to avoid blockage of the sensor by dirt or small particles.
4. Never attempt to take apart the units.
5. When the unit is not in