RYZE Tello 8520 Coreless Genuine CW CCW Motor for DJI Tello 720P Camera WiFi FPV Mini Drone Quadcopter Repair Accessories -Genuine M2 Motor -Long Black/Blue Line--

RYZE Tello 8520 Coreless Genuine CW CCW Motor for DJI Tello 720P Camera WiFi FPV Mini Drone Quadcopter Repair Accessories Specification: Item name: RYZE DJI Tello Genuine 8520 Coreless CW CCW Motors Voltage: DC 3.7V Shaft end play: 0.05-0.3mm No-load speed: 52000±10%RPM No-load current: 93mA (MAX) Load speed: 24200±6%RPM Load current: 2200mA (MAX) Starting voltage: 0.8V DC (MAX) Dielectric strengt: 5M? (MIN) Gross weight: 5.5g/pc Introduction This a motor replacement guide for the Ryze/DJI Tello. It require fine soldering and very careful motor installation. Step 1 install motor connectors - pull motor wires out of the arm/mount (does not require opening the drone or removing any screws). Pull the motor outs of the motor mount, not out of the main body. black -> black, white -> white blue -> black, red -> blue Step 2 install motors into mounts - fold wires to the side of the motor wires should be parallel and straight each wire aligns with a small grovve, or both wires together in one of the larger grooves for neater installation, wrap wires around the arms so that the connectors are meeting between the two struts of each arm Step 3 remove pinions and install motors remove the white pinions and discard, e.g. with small pliers or flat screw driver. Dont bend the shaft, be careful! install propellers CW - front/left & rear/right CCW - rear/left & front/right After installation of the motor connectors, future motor swap will be much easier.