Rear Bike Tail Light Bicycle Tail Light USB Charging LED Wireless Remote Control Riding Turn Signal Mountain Bike Safety Warning Light

Description: Battery capacity: 800mAh Charging time: 2h Use time after full: 3-4h Remote control battery: CR2025 3V lithium battery Light source: CPB Brightness: 20-35LM Shell material: ABS Waterproof rating: IPX4   Specifications: Installation Notes 1. First pull the fixing bracket socket of the tail light upwards and tighten the strap buckle into the car tube. Then insert the tail light switch upwards into the socket of the bracket. 2. Pull the rubber band of the remote control inward and go around the handlebar of the car, tighten and fasten it. 3. Please keep the charging cable separately. Instructions 1 Before use, press and hold the tail light power button for 4-6 seconds to confirm that the button light flashes. 2Then press and hold the middle button of the remote control for 3 seconds to confirm the induction connection. 3 The middle button on the remote control can control the red LED warning light of the tail light, and the left and right buttons respectively control the yellow LED direction indicator on the tail light. Battery and charging instructions Taillight: 1 Use the built-in 800Mah rechargeable battery. When charging, please press and hold the upper card board of the bracket inward to pull out the taillight, open the rubber charging port protector on the back of the taillight, insert the Micro plug and use the USB charging cable to charge. 2. The red indicator light of the charging port is on when charging, and the indicator light is green when it is fully charged. 3. The charging time is 2 hours, and it can be used for 3-4 hours after being fully charged. 4. Note that the battery inside the taillight is not allowed to be replaced by yourself.