Raven Washer Agitator Dogs 80040 fits Whirlpool Kenmore Washers Replaces Part Numbers AP3119063 3366877 387091 80040VP EA388034 ER80040 12 PACK

80040 agitator directional cogs are commonly referred to as dog ears, usually fit direct drive top-loading washing machines Whirlpool, Crosley, Maytag, Kenmore, KitchenAid, Roper, Inglis, and Estate Agitator dogs enable your washer to properly agitate to clean your clothes. When the teeth on the outer edges wear out, the agitator dogs stop gauging with the upper agitator. This makes your washer doesn’t work like it used to Could solve the following problems: - Will not agitate. - Noisy. - Pumps but will not spin. - Spins slowly. - Shakes and moves. - Not cleaning dishes properly. - Will not drain. - Marks left on clothes. - Does not dispense fabric softener/ detergent. Installation Tips: 1. Disconnect the washer from its power and water sources 2. You are going to need a 7/16 ths socket with a long extension and ratchet 3. Open the washer and get out the agitator, just simply grab hold and pull it off 4. Take the ratchet with the 7/16 socket, locate the bolt in center grab the base of the agitator to keep it from turning completely loosen that bolt 5. Reach down pull the agitator from the base 6. Take the bearing, you will note four little rounded, these are the agitator dogs. 7. Replaces old dogs and reassemble the agitator. Product specifications: - Quantity: : 12 pieces - Material: Plastic - Size: 2.4 x 1 x 1 cm/ 1 x 0.4 x 0.4 inch