This Leak Detector shuts off flow to the drinking water system in the event that a leak should occur. With an audible alarm and highly reliable design, this simple device provides better liability protection and can minimize water damage from a leak. Unlike other one-time use leak detectors, this unit can be reset and reused. It comes with one 9V battery and an instruction manual.I
Specification
- Operating voltage: 9V DC (Alkaline battery only)
- Supply Current: typical 1 mA, maximum 15 mA.
- Cable Length: 1.5 M for solenoid valve cord
- Connecting: 1/2 BSP male
- Water leak detecting method:
- Control unit with detecting metal put on the floor near water filter
- Environment temperature: -20 ~ 80?
- Maximum Pressure: 8 Bar
Installation Instruction
- Attach quick fitting with different type tube.
- Install solenoid valve in front of the inlet tube.
- Put the control unit on the lowest place of the floor. Please place a tissue under the control uni if the floor is made of metal.
- The metal sensor under the control unit detects water and sends a signal to the control unit to shut off the water in the event of a leak.