PCI-E Riser for Mining- PCIE 1x to 16x Graphics Card Extension Cable GPU Riser Adapter USB 3.0 6-Pin PCIE to SATA Power Cable for Bitcoin Litecoin Ethereum Mining ETH -60CM-

The high-performance PCI Express riser board can expand the motherboard PCIE X1 slot to the PCIE X16 slot. It will provide safe and reliable connections with more PCIE X16 graphics cards. Mainly designed for Ethereum mining equipment or more GPU mining equipment. Features 1. The graphics card power supply uses four FP solid capacitors to make the graphics card power supply stable 2. The extension cord has a 6P interface (16A power supply capability) to strengthen the power supply and solve the problem of insufficient power supply capacity to burn the line 3. The graphics card slot adopts the original imported connector with gold-plated contacts to make the graphics card contact well 4. The PCI-E connector uses multi-layer shielded wire, which can be connected to 3M without attenuating the signal 5. The cable is soft, easy to route, and the graphics card can be placed at will 6. The PCI-E connector plug is fully gold-plated, which is more wear-resistant and increases conductivity 7. The slot is equipped with a fixed buckle, which is convenient to remove and fix the graphics card, so that the graphics card will not fall off 8. It solves the problems of traditional flat cable solder joints that are fragile and easy to burn, transmission signal attenuation, and insufficient cable length. Installation steps (must be connected in the correct way, otherwise it may burn out!) 1. Connect one end of the USB cable to the small plug 2. Connect the other end of the USB cable to the adapter board 3. One end of the power cord is connected to the 6P port of the adapter board 4. Pick up the small plug and install it into the motherboard slot 5. Connect the other power port on the adapter board to the power port of the chassis 6. Install the graphics card into the adapter board slot 7. Find the 6P power supply line in the chassis to connect to the graphics card for power supply 8. Installation is complete