Material: TPU
Color: Transparent
Features: scratch resistant, self repairing
? Installation method ?
Step 1: Prepare a small watering can, cloth, and scraper,
Step 2: add water and 1ml shower gel in a small spray can, shake well,
Step 3: Do a good job in indoor cleaning and hygiene. This step is very important. Once the internal cleaning is completed, the installation of the internal film is half successful!
Step 4: Find the corresponding inner membrane and remove it, then use a small spray can to evenly spray the prepared liquid onto the surface of the adhesive. Spray the liquid evenly at the location to be installed, without needing too much. As long as it is uniform, it can be sprayed from a distance. Wipe off excess liquid from other parts first to avoid button short circuits,
Step 5: Fix the inner membrane inside, gently fix it with your hand, and gradually scrape out the liquid with a small scraper. At this point, the film may slide, it's okay, slowly reset. After scraping off most of the water, gently wipe off the excess water with a towel,
Step 6: Wait for 5 minutes to let the water dry slightly, and then use a small scraper to remove the water and bubbles. If there are any small impurities, gently remove them and scrape them off with a scraper. At this point, the surface of the thin film is relatively fixed,
Step 7: Enter the closing stage, use an electric hair dryer to blow with hot air, and then use a small scraper or directly stick the edge position with your hand to make the inner membrane properly coated!
Installation tips:
1. Do not work in rainy, rainy or freezing days. Do not clean the car within 48 hours after use.
2. Do not use chemical water, corrosive agent (such as cleaner), degreaser, etc. Wipe or spray on the protective film. (If you do not comply with the above provisions, we will not be responsible.
Color: Transparent
Features: scratch resistant, self repairing
? Installation method ?
Step 1: Prepare a small watering can, cloth, and scraper,
Step 2: add water and 1ml shower gel in a small spray can, shake well,
Step 3: Do a good job in indoor cleaning and hygiene. This step is very important. Once the internal cleaning is completed, the installation of the internal film is half successful!
Step 4: Find the corresponding inner membrane and remove it, then use a small spray can to evenly spray the prepared liquid onto the surface of the adhesive. Spray the liquid evenly at the location to be installed, without needing too much. As long as it is uniform, it can be sprayed from a distance. Wipe off excess liquid from other parts first to avoid button short circuits,
Step 5: Fix the inner membrane inside, gently fix it with your hand, and gradually scrape out the liquid with a small scraper. At this point, the film may slide, it's okay, slowly reset. After scraping off most of the water, gently wipe off the excess water with a towel,
Step 6: Wait for 5 minutes to let the water dry slightly, and then use a small scraper to remove the water and bubbles. If there are any small impurities, gently remove them and scrape them off with a scraper. At this point, the surface of the thin film is relatively fixed,
Step 7: Enter the closing stage, use an electric hair dryer to blow with hot air, and then use a small scraper or directly stick the edge position with your hand to make the inner membrane properly coated!
Installation tips:
1. Do not work in rainy, rainy or freezing days. Do not clean the car within 48 hours after use.
2. Do not use chemical water, corrosive agent (such as cleaner), degreaser, etc. Wipe or spray on the protective film. (If you do not comply with the above provisions, we will not be responsible.
