Original 3D Printer Extruder All Metal Assembled MK8 Hot End Kit Incredible Replacement for CR-10 CR-10S CR-10S4 CR-10S5 CR10MINI

Original 3D Printer Extruder All Metal Assembled MK8 Hot End Kit Incredible Replacement for CR-10 CR-10S CR-10S4 CR-10S5 CR10MINI Features: 9 cooling fins on MK8 extruder Hotend heatsink provide better heat distribution, extending the life of hot end ?MK8 Extruder Hot End kit, white wire was temperature thermistor, red wire was heating tube 12V 40W. MK8 hotend works great, and heat really fast (I usually get up to 200C in less than a minute-and-a-half to two minutes). Pre-insulated, helping to retain a steady temperature . Creality cannot support to add auto level sensor, cause auto level sensor cannot detect glass plate, it can detect metal material. You will make it running well after some bed leveling. Warm Tips: Why are theyunterminated? 1. Connector is not strong enough to hold during the printing process. 2. Connector will be increased resistance at the connection. 3. Connector on the hotend cables is NOT meant to handle the amps needed. You will at best melt them and at worst start a fire. Specification: Scope of application: 3D printer Nozzle size: 0.4mm Throat pipe length?30mm Aluminum block size: 20 mm x 20 mm x 10 mm Material: Aluminum & Stainless Steel & Brass Installation type: external thread connection Thermistor and heater cable length: 1M Operating temperature range: -40 ~ +260°C (-40 ~ +500 °F) Package Included: 1x Aluminum Block 1x Heating Tube (1 m long, 12V 40W) 1x 1.75mm 0.4mm Brass Nozzle 1x M6*30mm Throat Pipe (built-in Teflon) 1x Thermistor + Brass Sleeve (1 meter long) ?This Kit NOT include the instruction manual, we need to DIY :) Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.