Usage:
Step 1: use the wire clip to clamp the front wire disk
Step 2: The end of the front thread is facing up, and it is stuck into the left slot and also stuck at the bottom.
Step 3: face the main line of the pe line head up,stuck in the right
Step 4: Lift the net disk, tie the main line lightly with your right hand, wind it diagonally, and then turn it diagonally upwards
Step 5: Lift the spool, gently follow the main line with your left hand, wind it diagonally, and then diagonally upward
Step 5: remove the twisted wire
Step 6: smooth out the wire head pinch the front wire head and pe main line and use the pe wire head to wrap the two on a single knot
Step 7: Tighten the ends until the knot becomes tighter and darker (important)
Step 8: cut off the excess front plumb
Step 1: use the wire clip to clamp the front wire disk
Step 2: The end of the front thread is facing up, and it is stuck into the left slot and also stuck at the bottom.
Step 3: face the main line of the pe line head up,stuck in the right
Step 4: Lift the net disk, tie the main line lightly with your right hand, wind it diagonally, and then turn it diagonally upwards
Step 5: Lift the spool, gently follow the main line with your left hand, wind it diagonally, and then diagonally upward
Step 5: remove the twisted wire
Step 6: smooth out the wire head pinch the front wire head and pe main line and use the pe wire head to wrap the two on a single knot
Step 7: Tighten the ends until the knot becomes tighter and darker (important)
Step 8: cut off the excess front plumb
