NOYITO Frequency to Voltage Module 0 1KHz to 0 10V F V Conversion Module Input with Optocoupler Isolation Anti Interference

Feature 1. Input different frequencies and output the corresponding voltage. 2. Input pulse level is 5V 12V 24V can be directly input, no need to string resistor. However, the input signal frequency should be maintained for more than 0.5 seconds. 3. The output voltage can be fine-tuned. The relationship between frequency and voltage can be calibrated by a potentiometer. 4. The signal input with optical isolation to ensure anti-interference ability. 5. For use with PLC, support NPN type. Must have a ground wire. 6. If you need to use an encoder, the encoder should be rotated at a constant speed for more than 0.5 seconds. 7. F/V conversion module, response time is about 0.3-0.5 seconds. If the frequency is adjusted greatly at one time, a certain response time is required. Parameter: Working voltage: 13.5V-30V. Input frequency range: 0-1KHz. Output voltage range: 0-10V. Size:32x34mm Wiring instructions: VCC: Power supply + . GND: Power supply - / ground. F: Input frequency pulse signal. GND: Input ground. VOUT: Outputs the corresponding voltage. GND: Output ground. Instructions: Connect the working voltage to VCC and GND, and do not reverse the connection to avoid damage to the board and device. The frequency pulse signal is connected to F, and there is a corresponding voltage output at the VOUT terminal. Input and output correspondence: 100Hz = 1V. 1KHz = 10V. Module accuracy is 1%, If there is a deviation in the correspondence when using, you can adjust the potentiometer on the board to calibrate. Package Included 1Pcs NOYITO Frequency to Voltage Module