Neutop Filter Brush Replacement for iRobot Roomba e and i Series e5 i7 i7+ Robot Vacuums,12-Pack.

Fit Models: For iRobot Roomba e and i Series e5 i7 i7+ Models. What's In The Box: 6 x High-Efficiency HEPA Filters 6 x Edge-Sweeping Side Brushes with screw pre-installed Guides to Clean the Filters 1, Cleaning the filters is important to maximize the robots cleaning performance. You should clean them at least once in every week and at least twice if your home has many pets. 2, Replacement of the filter after every two months is important. 3, To remove the filter, start by taking out the dirty bin. 4, Empty your dirt bin and tap your filter against the side of a garbage receptacle to release the dirt and debris from the filter. 5, If you have a few extra minutes, however, you can use compressed air to blow out any caught debris. 6, Put the dirt bin back into its slot on top of the robot. Guides to Clean the side brush 1, Clean iRobot Roomba's spinning side brush at least once in a week. 2, Remove the screw and set it at a safer place. To remove it, use a small screw driver or even a coin. 3, After you have done this, the brush will just pop. Remove the brush and ensure that there is no hair or debris stuck inside of it. 4, Removing the hair prevents damages which it can cause to this brush. At the least, minor clogs can cause the Roomba to use more energy to make the brush turn and therefore keeping the brush free of hair will be a great advantage to you. 5, If there is more debris or hair stuck inside the robot's inner brush, you will have to apply force to loosen it. A great idea is to use a paper clip. NOTE This is NOT an original iRobot product and is NOT covered under any warranty by iRobot. The brand names and logos are registered trademarks of their respective owners. Any use of a brand name or model designation for a non-OEM product is made solely for purposes of demonstrating compatibility.