MPU6050 Module 3 Axis Accelerometer Gyroscope GY-521 Analog Gyro Sensors Breakout Board for Quadcopter Arduino Robotics Raspberry Pi Boards

The MPU-6050 sensor module contains an accelerometer and a gyro in a single chip. It is very accurate. Since the board contains 16-bits analog to digital conversion hardware for each channel, therefore it captures the x, y, and z channel at the same time. The sensor uses the I2C-bus to interface with the Arduino. Specifications: Model:GY-521 Pitch:2.54mm Chip: MPU-6050(three-axis gyroscope + three-axis accelerometer) Power supply: 3-5v (internal low dropout regulator) Communication modes: standard IIC communication protocol Chip built-in 16 bit AD converter, 16 bits of data output Gyroscope range: + 250 500 1000 2000 ° / s Acceleration range: ± 2 ± 4 ± 8 ± 16 g Pin Definition: VCC, GND, SCL, SDA, XDA, XCL, ADO, INT Board size : 20mm(length)*16mm(width) Gyroscope range: ± 250 500 1000 2000 ° / s Immersion Gold plating PCB, machine welding process to ensure quality Please note, these will NOT tell you the absolute angle that a device is being held at, they only sense short events like tilting or spinning. For that you need a 9axis (9DOF) module, OR you can connect a compass (magnetometer) to this module through the slave port. (basically turning this 6axis into a 9axis) Features: It is a really powerful device along with the 3 axis gyro and accelerometer It is quite sensitive, and can detect light tapping on the table top Applications: Various robotics Quadcopters Smart phone Tablet devices Handheld games Electronic Image Stabilization (EIS) Package List: 1 Pcs 3 Axis Analog Gyro Accelorometer Module 1 x straight header 1 x 90 degree header