MITAOHOH LED Night Light Portable Battery Powered Motion Sensor Night Light Indoor Stick-on Light with 3M Adhesive for Bedroom Kitchen Closet Stairs Step Hallway CabinetCool White6 Pack

Mitaohoh night light uses 12 LED light bulbs. Although it is small, it can provide enough light at night. The sensing range is 6-10ft and the sensing angle is 80 degrees; it will turn off automatically after 30-40 seconds when no further movement is detected. The lights are powered by 3pcs AAA batteries for non-core installation. No need to recharge, allowing you to save energy.The mains free design, and the customized 3M Super Sticky double-sided adhesive tape allow the night lights to be stuck wherever they are needed. Usage method: Push and open the light back cover, put in three AAA batteries. After the batteries are installed, clip the battery back cover back on, and attach one 3M adhesive tape to the battery back cover, and then stick the light on the wall or wherever you want. It is recommended to be at a height between 4.9ft and 5.5ft, so that it can detect the human movement. When the product detects the heat of a human body at night, the light will turn on immediately, and stay lit for about 30 seconds. After that, light will turn off and enter into the standby mode, and then wait for the next detection. When the product is used for a long time, the battery voltage will drop, and the light will become dimmer and dimmer, which means new batteries are needed. Be careful to make sure the positive and negative terminals of the batteries been connected correctly after installing new batteries, otherwise the product will be damaged. Note: 1.Please use 3 regular AAA batteries to match the night light, and kindly check whether the batteries have been installed in the correct direction. 2.Keep a minimum distance of 6ft when installing multiple units at the same time. 3.Avoid removing after sticking to a surface, the adhesive will be less effective if used again. 4.Keep away from fire and high temperature areas, or touch the water. 5.Avoid installing in a place that directly face an infrared beam.