MAYITOP WP9704329 Wire Whip Mixer for KitchenAid Dough Hook Stand Beater Head K45WW KSM90 KSM150

Feature - It can be used in mixers, milkshakes and noodle makers. - The product which is very firm stirs well has a good fit with devices. Fits for KitchenAid KSM15, KSM110, KSM103, KSM75, KN15, K45, and KSM90 models stand mixers. - 6 wire whip for quickly incorporating air into ingredients for fluffy whipped cream, perfect boiled frostings and cakes with whipped egg whites. - Low noise, easy to install and easy to clean. Attach/Remove a wire whip: To attach Wire Whip: 1) Turn speed control to OFF. 2) Unplug Stand Mixer or disconnect power. 3) Tilt motor head back. 4) Slip beater onto beater shaft and press upward as far as possible. 5) Turn beater to right, hooking beater over pin on shaft. 6) Plug into a grounded 3 prong outlet. To Remove Wire Whip: 1) Turn speed control to OFF. 2) Unplug Stand Mixer or disconnect power. 3) Tilt motor head back. 4) Press beater upward as far as possible and turn left. 5) Pull beater from beater shaft. Adjust the BEATER TO BOWL CLEARANCE: If the Wire Whip hits the bottom of the bowl or is too far away from the bowl, you can correct the clearance easily 1) Turn speed control to OFF. 2) Unplug Stand Mixer or disconnect power. 3) Tilt motor head back. 4) Turn beater height adjustment screw SLIGHTLY counterclockwise (left) to raise the Wire Whip or clockwise (right) to lower the Wire Whip. 5) Make adjustment so that the Wire Whip just clears the surface of the bowl. If you over adjust the screw, you may not be able to lock the motor head when it is lowered. This wire whip is for stand mixers. Wire whip attaches to the beater shaft and incorporates air into cream, eggs and frostings. Follow the instructions in the owner's manual for using and installing this part.Fits models:KitchenAid 3K45SS 3KSM150PSTBW0 3KSM150PSTCB0 3KSM150PSTCL0 3KSM150PSTCU0 3KSM150PSTER0 3KSM150PSTGA0 3KSM150PSTMY0