Matek F411-WING Flight Controller F4 FC Built-in OSD BEC Current Sensor on Board for RC FPV Racing Drone

FC Specifications     MCU: 100MHz STM32F411     IMU: MPU6000 accelerometer/gyro (SPI)     Baro: BMP280 (I2C)     OSD: INAV OSD w/ AT7456E chip     Blackbox: No     VCP & 2x UARTs     2x Motors, 5x Servos outputs     1x I2C     3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)     Built in inverter for SBUS input (UART1-RX)     SoftSerial_Tx1: ST1 pad by default     PPM: ST1 pad with softserial disabled     Battery Voltage Sensor: 1:10 (Scale 1100)     WS2812 Led Strip : Yes     Beeper : Yes     RSSI: No FC Firmware    NAV Flight     Target: MATEKF411 PDB   Input voltage range: 6.5~30V (2~6S LiPo) w/TVS protection     2x ESC power pads, Current Senor: 78A,  3.3V ADC,  Scale 423 BEC 5V output    Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed   Continuous current: 2 Amps BEC Vx output     Designed for Servos     Voltage adjustable, 5V Default, 6V via jumper     Continuous current: 3 Amps BEC 3.3V output     Designed for Baro / Compass module/ OLED and Spektrum RX     Linear Regulator, Continuous current: 200mA Physical     Mounting: 24 x 24mm, ?2mm Dimensions: 41 x 28 x 10mm     Weight: 7g (Total 12g w/ bottom plate and M2 standoffs)