MakerHawk I2C OLED Display Module 15 Inch OLED Module Arduino LCD Display SSD1327 Driver Chip 128x128 Pixels 16bit Grey Level with I2C Interface DC 33V 5V for Arduino

I2C OLED Display Module 1.5inch OLED Module Arduino LCD Display SSD1327 Driver Chip, 128x128 Pixels, 16-bit Grey Level with I2C interface,DC 3.3V/ 5V for Arduino Parameter: Driver chip: SSD1327 Interface: 2 wire IIC interface PCB Module size: 34.30mm * 48.5mm * 1.6mm Module interface: I2C Display color: white Gray scale: 16 bits High resolution: 128×128 Viewing angle: greater than 160° Operating voltage: 3.3V / 5V Module size: 45.5 * 34.3 (mm) Option:256 level contrast can be set Features: This is a general OLED display Module, 1.5inch diagonal, 128x128 pixels, 16-bit grey level, communicating via I2C interface. 128x128 high resolution, clearer display. On board level conversion chip for 5V/3.3V MCU 256 level contrast can be set commonly used IIC interfaceSupports for 16-bit grey level display which makes the sense of depth of the picture more stronger and more realistic. SSD1327 is a single-chip CMOS OLED/PLED driver with controller for organic/polymer light emitting diode dot-matrix graphic display system. It consists of 128 segments and 128 commons. This IC is designed for Common Cathode type OLED/PLED panel. Resolution: 128 x 128 matrix panel Embedded 128 x 128 x 4 bit SRAM display buffer 16 gray scale Pin selectable MCU Interfaces Screen saving continuous scrolling function in both horizontal and vertical direction Programmable Frame Rate Programmable Multiplexing Ratio Row Re-mapping and Column Re-mapping On-Chip Oscillator Power On Reset (POR) Chip layout for COG , COF Wide range of operating temperature: -40°C to 85°C Package Including 1 * I2C OLED Display Module