M5StickC+ IoT ESP32 Development Kit with ENV Hat and SPK Hat 0.96inch Color LCD Display Microphone 4MB Flash Wearable and Wall Mounted Watch Belt for Arduino MicroPython and UIFlow Programming

Power switch operation:
Power on: Long press power button for 2 seconds
Power on ?Short press power button for 6 seconds

Notice:
Baudrate supported by M5StickC: 1200 ~115200, 250K, 500K, 750K, 1500K
If you find out your M5StickC couldn't power on without a USB in, it might because the battery enter the battery protection mode, caused by low-volatge, over-charged, ver-heat...To exit the battery protection mode, please keep charging the battery for around 40 mins. Our team is working on the solution.

Features:
5V DC power supply
USB Type-C
ESP32-based
4 MByte Flash
6-Axis IMU SH200Q
Red LED
IR transmitter
Microphone
2 Buttons, LCD(0.96 inch), 1 Reset
2.4G Antenna: Proant 440
80 mAh Lipo Battery
Extendable Socket
Grove Port
Wearable & Wall mounted
Development Platform: UIFlow, MicroPython, Arduino

ESP32 Features:
240 MHz dual core Tensilica LX6 microcontroller with 600 DMIPS
Integrated 520 KB SRAM
Integrated 802.11b/g/n HT40 Wi-Fi transceiver, baseband, stack and LWIP
Integrated dual mode Bluetooth (classic and BLE)
Hall sensor
10x capactive touch interface
32 kHz crystal oscillator
PWM/timer input/output available on every GPIO pin
SDIO master/salve 50MHz
SD-card interface support

Package Including:
1 * M5Stack ESP32 Mini IoT Development Board M5StickC (Built in 80mAh Battery)
1 * Watch belt
1 * Wall/1515(Random Color)
1 * Brick (Random Color)
1 * USB Type-C cable (Random Color)
1 * HAT-ENV
1 * HAT-SPK